Resources
Disassembly and assembly
Disassembling the charging case: First open the lid and then try to press the case from the front edge with a plectrum or a thin card. There are two clips on each side. Soon the case will snap open. Carefully unscrew and remove the PCB from the case. Assembling the charging case:
ResourcesDisassembly guidepine64.org
ResourcesDisassembly and Reassemblypine64.org
ResourcesDisassembly and Parts Replacementpine64.org
ResourcesFurther informationpine64.org
ResourcesFrequently Asked Questionspine64.org
ResourcesFlashingpine64.org
ResourcesDisassemblypine64.org
ResourcesAssembly and disassemblypine64.org
ResourcesAssemblypine64.org
Products & ServicesOfficial Raspberry Pi 3 Model B Case Red/Whitedfrobot.com
Products & ServicesDF15MG Tilt/Pan Kit (15kg)dfrobot.com
Products & ServicesM3 x 20mm Nylon Hex Standoff Kit (10 Sets)dfrobot.com
Products & ServicesM3 30mm Hexagonal Standoff Mounting Kit (10 Sets)dfrobot.com
Products & ServicesM3 x 10mm Hexagonal Standoffs Mounting Kit (10 Sets)dfrobot.com
Products & ServicesM3 20mm Hexagonal Standoffs Mounting Kit (10 Sets)dfrobot.com
Products & ServicesM3 Flange Nuts (10 PCS) for Electronics Assemblydfrobot.com
Products & ServicesM3 Nylon Standoff Kit (10 Sets, 10mm) for PCB Mountingdfrobot.com
Products & ServicesM3 30mm Nylon Hex Standoff Set with Screws & Nutsdfrobot.com
Products & ServicesM3 Nylon Screw and Standoff Kit (10 Sets, 6mm)dfrobot.com
Products & ServicesDF05BB Tilt/Pan Kit (5kg)dfrobot.com