Resources
Assembly and disassembly
Be very careful here. It is not a ‘pop off’ cover design. Special care should be directed to AVOID anything that may appear to cause a “bend” in screen. Gently use fingernails (or if you have one, plastic pry), starting in the very middle location for each side (saving keyboard connector latch over area (bottom side) for the very last removal step).
ResourcesDisassembly and assemblypine64.org
ResourcesDisassembly guidepine64.org
ResourcesDisassembly and Reassemblypine64.org
ResourcesDisassembly and Parts Replacementpine64.org
ResourcesFurther informationpine64.org
ResourcesFrequently Asked Questionspine64.org
ResourcesDisassemblypine64.org
ResourcesAssemblypine64.org
Products & ServicesOfficial Raspberry Pi 3 Model B Case Red/Whitedfrobot.com
Products & ServicesDF15MG Tilt/Pan Kit (15kg)dfrobot.com
Products & ServicesM3 x 20mm Nylon Hex Standoff Kit (10 Sets)dfrobot.com
Products & ServicesM3 30mm Hexagonal Standoff Mounting Kit (10 Sets)dfrobot.com
Products & ServicesM3 x 10mm Hexagonal Standoffs Mounting Kit (10 Sets)dfrobot.com
Products & ServicesM3 20mm Hexagonal Standoffs Mounting Kit (10 Sets)dfrobot.com
Products & ServicesM3 Flange Nuts (10 PCS) for Electronics Assemblydfrobot.com
Products & ServicesM3 Nylon Standoff Kit (10 Sets, 10mm) for PCB Mountingdfrobot.com
Products & ServicesM3 30mm Nylon Hex Standoff Set with Screws & Nutsdfrobot.com
Products & ServicesM3 Nylon Screw and Standoff Kit (10 Sets, 6mm)dfrobot.com
Products & ServicesDF05BB Tilt/Pan Kit (5kg)dfrobot.com
Products & ServicesWhite Nylon Screw and Mounting Kit (M2, 260 PCS)dfrobot.com